Netis AD1103 Driver – Netis AD1103 driver is a software component that allows the operating system to communicate with Netis AD1103 Gigabit Ethernet PCI-E Adapter. For example, suppose that an application needs to read some data from a device. The application calls a function implemented by the operating system and the operating system calls a function implemented by the controller.
If you own Netis AD1103 PCIe Adapter and looking for drivers to connect your device to the computer, you have landed on the right site. You can download Netis AD1103 driver here, with a simply click on the “Download Link” below.
The netis AD1103 is a PCI-E 10/100 / 1000Mbps interface adapter that reduces processor load using a master bus architecture. It is also compatible with WOL and RPL / PXE BOOT-ROM. With a single protocol UTP / STP and automatic negotiation (Nway), the adapter can automatically negotiate speeds of 10 Mbps, 100 Mbps or 1000 Mbps and full duplex or full duplex mode with its link partner (a hub, for example). By offering broad compatibility with major operating systems, it is a good choice for network updates.
Netis AD1103 Features:
Supports PCI-E interface
Meets IEEE 802.3 standards 10Base-T, IEEE 802.3u 100Base-TX, IEEE802.3ab 1000Base-T
Supports network bandwidth up to 20/200 / 2000M full duplex
Support for RPL / PXE BOOT-ROM
Compatibility with Windows XP / Vista / 7/8 / 8.1 / 10, Linux, MAC OS 10.4 ~ 10.7
Supports PCI-E interface
Meets IEEE 802.3 10Base-T standard; IEEE 802.3u 100Base-TX; Standards IEEE802.3ab 1000Base-T
Supports full duplex; Network bandwidth up to 20/200 / 2000M
Support for RPL / PXE BOOT-ROM
Compatible with Windows 2000 / Windows XP / Windows Vista / Windows 7; Linux; MAC OS
Netis AD1103 Driver Download
In most cases, the Windows drivers found here are “self-extracting” (.exe) files. Click on the desired file. When prompted, set the destination on your desk. Create a new folder and move the file to it. Click on the file to automatically extract the software and the associated files in your new folder. You can also extract or move these files to a floppy disk. Note that these files will only be self-extracting if they are run from Windows. After extracting the files to a disk or special directory, locate the installer, usually called “setup.exe” or “install.exe”, and then click on it to start the installation.
Sometimes, there is no installer because you have to install your driver through the Windows “Add a device” function. You can find instructions for installing drivers in the Windows Help file. Our Mac OSX files are also self-extracting. These files must be downloaded and executed in the same way. The installer will be present on the desktop once completed: click on it and follow the instructions to install it.