Net-DYN 300M2 Driver – Net-DYN 300M2 driver is a software component that allows the operating system to communicate with Net-DYN 300M2 Wifi Adapter. For example, suppose that an application needs to read some data from a device. The application calls a function implemented by the operating system and the operating system calls a function implemented by the controller.
If you own Net-DYN 300M2 Wifi Adapter and looking for drivers to connect your device to the computer, you have landed on the right site. You can download Net-DYN 300M2 driver here, with a simply click on the “Download Link” below.
I just received this Net-Dyn USB WiFi adapter yesterday afternoon from Amazon. Today, at 1 pm, Net-Dyn sent me an email informing me that I should have received my adapter and gave me a link to the driver and the installation files in Windows 8 or 10! ) Good touch, Net-Dyn! I do not think I bought a product and the manufacturer contacted me so quickly to help with the installation without being asked, so I added stars for that.

So let’s move on to the product ……
1) Adjustment and finishing. This USB adapter is well packed with the USB part separated from the antenna and the mini installation disk in the box behind the adapter. The packaging was easy to open, without the need for scissors or knives. The product is manufactured safely and the antenna is screwed without any problem and the angle is adjustable.
2) The installation. I’m using Windows 7 64-bit, Ultimate Edition. I plugged the adapter into a free USB port and Windows 7 immediately tried to install the adapter drivers, but came back 30 seconds later with a message that the drivers were NOT installed with success. I removed the mini installation disk, clicked on the installation file and installed the drivers and software. After restarting my computer, the adapter was immediately removed. All I had to do at this time was find my wireless network and enter the security phrase. Immediately I realized that my signal was excellent! I’m about 20 meters from my router, through several walls and I know what my wireless signal is in general. This adapter works better than the wireless card installed on my PC! I think the antenna has a lot to do with that!
3) The Realtek 11n USB wireless utility that comes with the installation disk is good software! Not only does this allow you to easily connect to your WiFi network, but you can also change the mode of the adapter to access point mode and use the adapter as an access point. I know the signal in my master bedroom is pretty ugly with my current WiFi configuration. With this adapter plugged into my PC one floor below and on the other side of the house compared to my main bedroom and in AP mode (access point), my WiFi signal has been improved! Good job, Net-Dyn!4) With the adapter in Station mode, I went to Speedtest.net and tested the downstream and upstream speeds through WiFi and I have a screenshot below. This adapter is of equal speed, with my cable connection! Woo Hoo!
Net-DYN 300M2 Driver Download
In most cases, the Windows drivers found here are “self-extracting” (.exe) files. Click on the desired file. When prompted, set the destination on your desk. Create a new folder and move the file to it. Click on the file to automatically extract the software and the associated files in your new folder. You can also extract or move these files to a floppy disk. Note that these files will only be self-extracting if they are run from Windows. After extracting the files to a disk or special directory, locate the installer, usually called “setup.exe” or “install.exe”, and then click on it to start the installation.
Sometimes, there is no installer because you have to install your driver through the Windows “Add a device” function. You can find instructions for installing printers in the Windows Help file. Our Mac OSX files are also self-extracting. These files must be downloaded and executed in the same way. The installer will be present on the desktop once completed: click on it and follow the instructions to install it.