HP ProBook 655 G2 Bluetooth Driver – HP ProBook 655 G2 Bluetooth driver is a software component that allows the operating system to communicate with HP ProBook 655 G2 Bluetooth Adapter Card.
If you own HP ProBook 655 G2 and looking for Bluetooth drivers, you have landed on the right site. You can download HP ProBook 655 G2 Bluetooth driver here, with a simply click on the “Download Link” below.
Like the ProBook 650 G2, the ProBook 655 G2 generates very little noise. At rest, the fan operates at low speed. It is barely audible because it is choked by the hard drive. Also, during the resistance test, the fan does not turn on. We measured a sound pressure level of 33.5 dB, an excellent value. Here, the strong limitation of the processor and graphics processor during the stress test is noted. Our resistance test (Prime95 and Furmark for at least one hour) is performed in the same way in the ProBook in AC mode and battery. The processor and graphics processor only run at high speed for a short time. Then the limitation applies to 1.2 GHz (processor) and 300 MHz (graphics core). The computer only heats moderately. During the stress test, the 40 ° C mark is not exceeded at any measurement point.

At rest, we recorded a maximum power consumption of 8.6 watts, a good result. During the stress test, the power consumption temporarily increases to 42.1 watts and then decreases to 30.5 watts. The reason: the processor and graphics processor are reduced. The nominal power of the power supply is 45 watts. With our convenient Wi-Fi test, we simulate the load when browsing the different pages of the website. The “balanced” profile is active and the energy saving mode is inactive. In general, we reduce the brightness of the screen to approximately 150 cd / m². This is not possible with the ProBook. In battery mode, the maximum brightness is 81 cd / m². The ProBook reaches a run time of 5:14 pm, almost two hours less than the ProBook 650 G2 (7:04 pm).
HP ProBook 655 G2 Bluetooth Driver Download
- Make sure you are logged in with an administrator account.
- Locate the folder where the file was downloaded.
- Locate the downloaded file and double-click on it.
- Follow the instructions on the screen.
- In the Select destination location window, click “Next”. If you want to select another folder, click Browse.
- In the Ready for installation window, click “Install.” All the necessary files will be extracted in the selected folder.