Edup AC1617 Driver – Edup AC1617 driver is a software component that allows the operating system to communicate with Edup AC1617 Wifi Adapter. For example, suppose that an application needs to read some data from a device. The application calls a function implemented by the operating system and the operating system calls a function implemented by the controller.
If you own Edup AC1617 Wifi Adapter and looking for drivers to connect your device to the computer, you have landed on the right site. You can download Edup AC1617 driver here, with a simply click on the “Download Link” below.
USB dual-band AC adapter 1200Mbps USB with internal antennas. EP-1617 is an 802.11b / g / n / a / ac wifi adapter. It can reach 300 Mbps for 2.4 GHz and 867 Mbps for 5.8 GHz. It can be combined with a WiFi repeater of 5.8 ghz / apg and a Wi-Fi router perfectly.
Edup AC1617 Specs
1.Support USB3.0
Frequency 2.Support 20MHz / 40MHz / 80MHz
3.5G compatible with IEEE 802.11ac and IEEE 802.11a standards
4.2.4G compatible with IEEE 802.11n, IEEE 802.11g, IEEE 802.11g standards
5. It detects the network and automatically changes the transmission speed.
6.Support WEP / WPA2 / WPA-WPA2 / 802.1x and 64/128-bit WEP Encryption
7.WPS 2.0 support
8. Internal omnidirectional antenna
9.Support 2.4G and 5G dual band
10.Support Wi-Fi Direct
11. Multiple BSSID support
12.Support QoS-WMM, WMM-PS
13. WPS Support: PIN, PBC
14. Infrastructure support mode, Ad-Hoc mode and three soft AP modes
15.Cisco CCX Support
16. Consumption management.
17. Compatible operating system: Windows XP / Vista / Win7 / Win8.1 / Win10 compatible; Mac OS10.6 ~ 10.14;
Edup AC1617 Driver Download
In most cases, the Windows drivers found here are “self-extracting” (.exe) files. Click on the desired file. When prompted, set the destination on your desk. Create a new folder and move the file to it. Click on the file to automatically extract the software and the associated files in your new folder. You can also extract or move these files to a floppy disk. Note that these files will only be self-extracting if they are run from Windows. After extracting the files to a disk or special directory, locate the installer, usually called “setup.exe” or “install.exe”, and then click on it to start the installation.
Sometimes, there is no installer because you have to install your driver through the Windows “Add a device” function. You can find instructions for installing printers in the Windows Help file. Our Mac OSX files are also self-extracting. These files must be downloaded and executed in the same way. The installer will be present on the desktop once completed: click on it and follow the instructions to install it.