Edup AC1601 Driver – Edup AC1601 driver is a software component that allows the operating system to communicate with Edup AC1601 Wifi Adapter. For example, suppose that an application needs to read some data from a device. The application calls a function implemented by the operating system and the operating system calls a function implemented by the controller.
If you own Edup AC1601 Wifi Adapter and looking for drivers to connect your device to the computer, you have landed on the right site. You can download Edup AC1601 driver here, with a simply click on the “Download Link” below.
EP-AC1601 USB Dual-band AC USB Adapter: 802.11b / g / n / ac wifi adapter. It can reach up to 300 Mbps for 2.4 GHz and 867 Mbps for 5.8 GHz. Use 5.8Ghz. It can be combined with the 5.8ghz / ap wifi repeater and the wifi router perfectly.
Edup AC1601 Features:
1.Support USB3.0
2.Support 20MHz/40MHz/80MHz frequency
3.5G compatible with IEEE 802.11ac and IEEE 802.11a standard
4.2.4G compatible with IEEE 802.11n, IEEE 802.11g, IEEE 802.11g standard
5.Detect the network and change transmit speed automatically
6.Support WPA/WPA2/WPA-WPA2/802.1x and 64/128 bit WEP encryption
7.Support WPS 2.0
8.Internal Omni-directional Antenna
9.Support 2.4G and 5G dual band
10.Support Wi-Fi Direct
11.Support Multiple BSSID
12.Support QoS-WMM, WMM-PS
13.Support WPS: PIN, PBC
14.Support Infrastructure mode, Ad-Hoc mode and Soft AP three modes
15.Support Cisco CCX
16.Low consumption management
17.Supported Window 2000/XP/Vista/Win7/Win8/Win8.1/Win10; Mac OS10.9~10.11; Linux v3.0.0.1
Edup AC1601 Driver Download
In most cases, the Windows drivers found here are “self-extracting” (.exe) files. Click on the desired file. When prompted, set the destination on your desk. Create a new folder and move the file to it. Click on the file to automatically extract the software and the associated files in your new folder. You can also extract or move these files to a floppy disk. Note that these files will only be self-extracting if they are run from Windows. After extracting the files to a disk or special directory, locate the installer, usually called “setup.exe” or “install.exe”, and then click on it to start the installation.
Sometimes, there is no installer because you have to install your driver through the Windows “Add a device” function. You can find instructions for installing printers in the Windows Help file. Our Mac OSX files are also self-extracting. These files must be downloaded and executed in the same way. The installer will be present on the desktop once completed: click on it and follow the instructions to install it.